Celestron StarHopper 10 Instruction Manual page 9

Now that the base is fully assembled you can attach the eyepiece accessory tray, handle and altitude
nylon bearing cylinders:
Align the eyepiece accessory tray with the holes in the side panel and attach with two ½" wood
screws.
Align the base handle with the thread holes in the front panel. Insert a bolt through the handle and
thread into the front panel.
Figure 3
Align each altitude nylon cylinder with the holes on the inside of the side panels of the base. From
the outside of the side panels, insert a 1 ¼" Allen head bolt through the hole and thread it into each
nylon cylinder.
Figure 2
Figure 2
Nylon
Cylinder
1¼" Allen
head bolt
Figure 4
9