Registration; Find The Handset; Conference Call - Swissvoice Xtra 2355 User Manual

7.7.

Registration

Your handset and telephone base is pre-registered. If for some reason, the handset
is not registered to the base station, PUT ON BS TO POWER will be displayed on the
handset screen If it is out of base and
handset according to the following procedure.
1. Make sure the handset is out of the base and shows PUT ON BS TO POWER
before you begin registration.
2. Press and hold
until incoming call light LED bar lits on the telephone base.
3. Press when idle.
4. Press or
5. Press or
flashes on the screen until the handset can be registered with base.
If registration fails, the telephone base screen displays PUT ON BS TO POWER.
Pls. repeat the above procedure.

7.8. Find the Handset

You can locate the handset by pressing
the main base.
All the handsets registered to the base will produce the paging tone and "PAGING"
is displayed on the LCD of the handsets.
You can stop the paging by pressing
on the base again.
Note: If there is an incoming call during paging, the phone will ring with the
incoming call instead of paging.

7.9. Conference call

Up to 5 cordless handsets and the telephone base can join an external call
at the same time.
To join a call with a cordless handset:
• Press
• Press
To join a call with the telephone base:
• Press to join the call,
• Press again, to exit the call.
on the telephone base in idle mode for around 5 seconds
to select HS SETTING, then press
to select REGISTER, then press
join the call.
or place the handset in the base or charger to exit the call.
disappears on the screen, register your
.
, REGISTRNG appears and
once on the paging key, located under
, , on any handset or
24