Husqvarna 555FX Operator's Manual page 18

2. Set the choke control (A) to the choke position.
B
3. Push the air purge bulb (B) approximately 6 times
until fuel starts to fill the bulb. It is not necessary to
fill the air purge bulb fully.
4. Push the decompression valve (C).
Note:
The decompression valve moves to the
initial position when the product starts.
5. Hold the body of the product on the ground with your
left hand.
CAUTION:
the product.
6. Pull the starter rope handle slowly until you feel
some resistance. When you feel resistance, pull the
starter rope handle quickly and with force.
Note:
Do not wind the starter rope around your
hand.
7. Continue to pull the starter rope handle until the
engine starts.
CAUTION:
rope to full extension and do not let go of
the starter rope handle. Release the
starter rope slowly. If you do not obey
these instructions, the engine can
become damaged.
18
C A
Do not put your feet on
Do not pull the starter
8. Set the choke control to the operation position and
apply full throttle.
To start a warm engine
1. Set the stop switch to the start position.
2. Push the air purge bulb (A) approximately 6 times
until fuel starts to fill the bulb. It is not necessary to
fill the air purge bulb fully.
A
3. Pull the choke control (B) up and down to set start
throttle.
4. For 555RXT, 555FRM: To engage the throttle
function, push and release the throttle trigger
lockout, the throttle trigger and the start throttle
button (C).
5. Hold the body of the product on the ground with your
left hand.
CAUTION:
the product.
B
C
Do not put your feet on
1346 - 004 - 03.06.2021