Celestron 114LCM Quick Setup Manual page 2

114LCM Telescope
10
Secure the tube to the base by
tightening the locking screw on the
top of the base.
13
Attach plastic hand control holder to
the tripod leg.
16
Press the tab on the front of the
battery compartment and remove
the cover.
19
Return the battery holder back inside
the base and replace the cover.
Before you can begin observing,you must setup your hand control,
align your finderscope and align your telescope. Step by step
instructions are included in the following Hand Control Setup section.
1 1
Select the low power (25 mm)
eyepiece and insert it as shown
above.
14
Slide Computerized Hand Control
into the hand control holder as
shown above.
17
Gently remove the battery holder
from inside the battery compartment.
20
Before you begin viewing, please
remember to remove tube lens cap.
Quick Set-up Guide
12
Tighten silver screw to secure.
15
Plug Computerized Hand Control
into the "Hand Control" port on
the fork arm.
18
Place 8-AA batteries (user supplied)
inside the battery holder.
21
While observing, tube should be
positioned as shown above.