Table of Contents
Advertisement
2.8 Logging into the Controller via Web Interface Access
Procedure
Internet Explorer, version 6 or newer, is supported (IE 8.0 is recommended). Chrome, Safari, and Firefox are also supported.
1.
In your browser, enter http:// and the controller's IP address (see "Connecting a Local Computer Directly to the Controller
when the System is NOT Equipped with an IB4 Board" on page 22 or "Connecting a Local Computer Directly to the Controller
when the System IS Equipped with an IB4 Board" on page 24) and press ENTER. If your site requires secure HTTP and you
were furnished with an NCU configuration with secure HTTP, enter https:// and the controller's IP address and press ENTER.
2.
If this is the first time the NCU is accessed remotely, the following screen appears. This informs a User to change the default
password the first time the NCU is accessed remotely. If the below procedure was performed, for subsequent logins the
window in the next step appears.
a)
Enter the old password (default 640275).
b)
Enter a new password.
c)
Re-enter the new password.
d)
Click the "Confirm Button".
NOTE!
By default, the "User Name" is "admin" and the "Password" is "640275". See also "Users Tab" on page 172.
3.
The following Web Interface Login window opens. Enter a valid User Name and Password, then click LOGIN.
NOTE!
Before entering a User Name and password, you can select a local language that the Web Interface menus use from
those listed in the top right corner of the login window. See "Language Tab" on page 185.
Vertiv™ NetSure™ Control Unit (NCU) User Manual
29
Hide quick links:
Advertisement
Table of Contents
