Advertisement
CONTENTS
INTRODUCTION/WARRANTY ..........................................2
SAFETY ...............................................................................2
INSTALLATION................................................................3-5
SERVICE ..............................................................................5
PARTS .................................................................................5
FULL TWO YEAR WARRANTY ON CRAFTSMAN HYDRO-GLASS
For two years from the date of purchase, Sears will repair or replace this sump pump, free of charge, if defective in material
or workmanship. This warranty does not cover repairs or replacement parts necessary because of abuse or negligence, in-
cluding failure to install, adjust and operate this pump according to the instructions in the owner's manual.
SEARS WILL NOT BE LIABLE FOR LOSS OR DAMAGE TO PROPERTY OR ANY INCIDENTAL OR CONSEQUENTIAL
LOSS OR EXPENSE FROM PROPERTY DAMAGE DUE DIRECTLY OR INDIRECTLY FROM THE USE OF THIS PROD-
UCT.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclu-
sion may not apply to you.
WARRANTY SERVICE IS AVAILABLE BY SIMPLY CONTACTING THE NEAREST SEARS SERVICE CENTER/DEPART-
MENT IN THE UNITED STATES of AMERICA. For service outside the U.S.A., contact your local Sears Service Center or
Store.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Electrically powered sump pumps normally give many years of trou-
ble-free service when correctly installed, maintained, and used.
However, unusual circumstances (interruption of power to the
pump, dirt/debris in the sump, flooding that exceeds the pump's
capacity, electrical or mechanical failure in the pump, etc.) may pre-
vent your pump from functioning normally. To prevent possible
water damage due to flooding, consult your local Sears store about
installing a secondary sump pump or a DC backup sump pump. See
"Service", Page 5, for information about common sump pump prob-
lems and remedies.
1. Know the pump application, limitations, and potential hazards.
Do not use in explosive atmospheres.
Pump water only with this pump. Failure to follow this
warning can result in personal injury and/or property
damage.
2. Disconnect power before servicing.
3. Release all pressure within the system before servicing any com-
ponent.
4. Drain water from the system before servicing.
5. Secure the discharge line before starting the pump. An unse-
cured discharge line will whip, possible causing personal injury
and/or property damage.
6. Check hoses for weak or worn condition before each use, mak-
ing certain that all connections are secure.
7. Periodically inspect pump and system components. Perform
routine maintenance as required (See MAINTENANCE).
8. Provide a means of pressure relief for pumps whose discharge
line can be shut-off or obstructed.
9. Personal Safety:
a. Wear safety glasses at all times when working with pumps.
b. Keep work area clean, uncluttered and properly lighted - re-
place all unused tools and equipment.
c. Keep visitors at a safe distance from the work area.
d. Make workshop child-proof - with padlocks, master
switches, and by removing starter keys.
LIMITATION OF LIABILITY
Sears, Roebuck and Co., Dept. 817 WA, Hoffman Estates, IL 60179
GENERAL SAFETY INFORMATION
INTRODUCTION
Please read our instructions before you install and use your
new pump; this will help you obtain full value and good ser-
vice from it. It will also help you avoid needless service costs
that result from causes we cannot control and cannot cover
in our warranty.
10. When wiring an electrically driven pump, follow electrical and
safety codes, as well as the most recent National Electrical Code
(NEC) and the Occupational Safety and Health Act (OSHA).
11. This equipment is only for use on 115 volt (single phase) and is
equipped with an approved 3-conductor cord and 3-prong,
grounding-type plug.
To reduce the risk of electric shock, pull
plug before servicing. This pump has not been investi-
gated for use in swimming pool areas. This pump is sup-
plied with a grounding conductor and grounding-type
attachment plug. Be certain that it is connected only to a
properly grounded grounding-type receptacle.
Where a 2-prong wall receptacle is encountered, it must
be replaced with a properly grounded 3-prong recepta-
cle installed in accordance with the National Electrical
Code and local codes and ordinances.
12. All wiring should be performed by a qualified electrician.
13. Make certain that the power source conforms to the require-
ments of your equipment.
14. Protect electrical cord from sharp objects, hot surfaces, oil, and
chemicals. Avoid kinking the cord. Replace or repair damaged
or worn cords immediately.
15. Do not touch an operating motor. Modern motors are designed
to operate at high temperatures.
16. Do not handle a pump or pump motor with wet hands or when
standing on a wet or damp surface, or in water.
Risk of electric shock. If your basement has
water or moisture on the floor, do not walk on wet area until
all power has been turned off. If shut-off box is in base-
ment, call the electric company to shut-off service to the
house, or call your local fire department for instructions.
Remove pump and repair or replace. Failure to follow this
warning can result in fatal electrical shock.
2
®
SUMP PUMP
Advertisement
