Table of Contents
Advertisement
1. Place the 3 Gallon Tea Dispenser, with Brew-thru Cover, onto the base of the Brewer with the hole in the
cover positioned under the brew funnel.
2. Place 3 oz. Tea Bag on brew funnel platform, and insert into brewer.
3. Pour two ½ Gallon Pitchers of Cold Tap Water through the screened top opening.
4. When the green Brew Light goes out and the funnel stops dripping (approx. 10 minutes after the start),
remove the Dispenser cover and add Cold Tap Water to the TEA CONCENTRATE up to the 3 Gallon
mark.
• Shut off HEATER SWITCH [toggle down]. This will bypass the lockout circuit.
Unplug the power cord.
Remove the front panel.
Remove Plug at the bottom of the generator and drain the generator tank.
Replace Plug and pour one (1) cup of de-limer or white vinegar through the to opening and let stand overnight to
fully dissolve all lime deposits.
Remove Plug and drain the generator tank of the residue.
With Plug removed, pour an additional decanter of warm water through the top opening to fully rinse out any
remaining dissolved residue.
Unplug the power cord.
Remove the front panel.
Remove drain plug and drain generator tank.
Disconnect electrical wires from the generator element and the hi-limit switch (see illustration).
Remove 2 mounting screws and hose from flow switch, then pull generator down
Service or replace the generator.
Unplug the power cord.
Remove the front panel.
Remove the hose clamps and hoses from the flow switch.
Remove wire leads from the switch by gently wiggling the wire terminals of the switch connector (Note position
of wires before disconnecting them from the switch).
Check the switch for obstructions and replace if necessary.
Assemble in reverse order.
TO BREW:
DELIMING PROCEDURE:
TO REMOVE THE GENERATOR:
TO REMOVE FLOW SWITCH:
Advertisement
Table of Contents
