Table of Contents
Advertisement
5. DUAL WATER INLET VALVE:
The Water Inlet Valve is located on the lower part of the main body with
the threaded end protruding out of in the back.
The Water Inlet Valve allows water flow up to .87 gal./min. [gpm].
One side supplies water to the tank and one side supplies water directly
to the Iced Tea dilution water nozzle. The time that each side draws
water is controlled by the Hot Water timer and Cold Water Timer.
6. DISPENSE VALVE:
Locate Dispense Valve, by removing the top lid of machine.
Looking down into the machine, the Dispense Valve is mounted on the tank.
FIXED FLOW: 1 LITER/ MINUTE [0.26 gal./ minute]
TB-3
3 liters in 3 minutes [0.78 gal. in 3 minutes]
TB-5
5 liters in 5 minutes [1.3 gal. in 5 minutes]
7. THERMOSTAT ADJUSTMENT:
Locate Thermostat: Remove the top cover. Thermostat is mounted on top of tank.
The thermostat is factory set to deliver hot brewing water at 195°F with the thermostat
knob turned to full ON position. If adjustments should be necessary to increase or
decrease the water TEMPERATURE, proceed as follows:
To INCREASE the water temperature,
Turn Thermostat Shaft to its maximum clockwise, CW, position.
Remove the knob and locate the Slotted Adjustment Screw inside
the hollow thermostat shaft. Using a narrow-bladed screwdriver,
engage slotted adjustment screw and turn it ¼ turn slowly counterclockwise, CCW.
Allow a few minutes for the temperature to reach set level. The Heater Light will go ON,
indicating the heating element is activated, wait for it to go OFF, indicating that the water
has reached new set temperature. Take a temperature reading and repeat if necessary.
To DECREASE the water temperature - simply turn the Thermostat Knob one notch
counterclockwise CCW to the next lower dial setting.
CD241
WATER INLET VALVE
L467A
DISPENSE VALVE
L681A
THERMOSTAT
Advertisement
Table of Contents
