Operation; Troubleshooting - Water Ace R5PILT Owner's Manual

OPERATION

Do not touch sump pump, pump motor,
water, or discharge piping when pump is connected to elec-
trical power. Always disconnect pump cord (power) before
handling.
1. Plug this unit into a 115V outlet, on an individual branch
circuit, with a Class A, 15 amp GFCI (Ground Fault Circuit
Interrupter).
Consult your local electrician for information
and availability.
2. Fill sump pit with water, pump will start automatically
when lower rod stop actuates switch lever arm. When
upper rod stop actuates switch lever arm, pump will stop.

TROUBLESHOOTING

Unplug pump from power receptacle before working on pump.
SYMPTOM POSSIBLE CAUSE(S)
Motor will not No electrical power
startor run
Low line voltage
Faulty automatic switch
Float or float rod stuck
Waterlogged float
Motor overload tripped
Electrical malfunction
Motor runs but Inlet clogged
pump will not
Discharge line plugged
pump
Low line voltage
Pump airlocked
Broken impeller or shaft
Pump starts and Improper positioning of
stops too often float rod stop
Faulty automatic switch
Pump is noisy Improper installation
Noisy motor
Pump will not Debris around float or
stop running float rod stuck
Faulty automatic switch
Motor defective
WA584
NOTICE: Do not allow pump to run dry.
Before attempting to service, always dis-
connect power from unit.
3. The motor is equipped with an automatic reset thermal
protector to protect unit from overheating. When motor
has cooled sufficiently, switch will reset automatically and
restart motor. Repeated tripping could be caused by low
voltage, long extension cords, clogged impeller, very low
head or lift, etc. Cycling of protector will cause eventual
motor burnout.
CORRECTIVE ACTION
Check fuse, circuit breaker, power cord and
electrical outlet.
If voltage wiring under recommended minimum,
check size of wiring from main source. If OK,
contact Electric Company or local Hydro authority.
Operate switch manually and replace if inoperative.
Check to see float is not rubbing sump wall or float
rod rubbing or stuck against sump cover.
Replace float if filled with water.
If pump has been running and stops before sump
is emptied, automatic overload may have tripped.
Check inlet screen to be sure impeller is not
jammed. If so, free impeller of obstruction.
Check power cord, automatic switch and motor.
Replace faulty parts as needed.
Check inlet and clean if needed.
Clear discharge line and check valve for
obstruction.
Refer to Corrective Action on low line voltage in
above section.
Drill a 1/8" (3.2mm) hole in discharge pipe just
above pump body but below the check valve.
Replace impeller or shaft as needed.
Lower float rod stop.
Replace automatic switch.
Refer to No. 5 in Installation Instructions.
Replace pump.
Remove debris from sump. Check to see float is
not rubbing sump wall or float rod rubbing or stuck
against sump cover.
Replace switch.
Replace pump.
4