EnGenius EZ Hotspot V3 Setup
  1. Manuals
  2. Brands
  3. EnGenius Manuals
  4. Extender
  5. EZ Hotspot V3
  6. Setup
EnGenius EZ Hotspot V3 Setup

EnGenius EZ Hotspot V3 Setup

Hide thumbs
1
2

Advertisement

Table of Contents

EZ Hotspot Extender
1

Remove the rear bottom panel.

2
Connect one end of the Ethernet cable (not supplied) to the LAN
(PoE) port on the EZ Hotspot Extender. The LAN (PoE) port can be
founded on the right-hand side as seen from the back of the device.
3
Connect the other end of the Ethernet cable to the PoE injector's
PoE port. Connect the power adapter DC inlet to the 24V DC IN of
the PoE Injector and the power adapter to an electrical outlet. The
device is ready for configuring when the two LEDs (Power and
Wireless) are lit and the green LED stops blinking. This may take
about 30 seconds.
EnGenius Europe | Veldzigt 28, 3454 PW Utrecht (NL)
0900-WIFIABC | www.wifiabc.com
Disclaimer: Information may be subject to changes without prior notification.
EZ Setup V3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EZ Hotspot V3 and is the answer not in the manual?

Questions and answers

Related Manuals for EnGenius EZ Hotspot V3

Summary of Contents for EnGenius EZ Hotspot V3

  • Page 1 LEDs (Power and Wireless) are lit and the green LED stops blinking. This may take about 30 seconds. EnGenius Europe | Veldzigt 28, 3454 PW Utrecht (NL) 0900-WIFIABC | www.wifiabc.com Disclaimer: Information may be subject to changes without prior notification.
  • Page 2 You can find this address at the back panel of your product. Enter your password (this is also on the back panel). Type ezhotspot.eu in your browser. Select which option applies at your location. For an extended installation version see www.engenius-europe.com. https://www.linkedin.com/company/engeniuseurope https://twitter.com/engeniuseu Follow us https://plus.google.com/+EngeniusEuropeBVDeMeern...

Table of Contents