BMW F 800 R Rider's Manual page 64

Programming DWA
5
62
Deactivate alarm function
( 60).
Switch on the ignition.
z
Press button 1 three times.
Acknowledgment tone sounds
once.
Switch off the ignition within
ten seconds.
Press button 2 three times.
Acknowledgment tone sounds
once.
Switch on the ignition within
ten seconds.
Acknowledgment tone sounds
three times.
The programming function is
active.
The actual programming is car-
ried out in four steps, and Step 2
is not assigned any function. The
number of flashing signals on the
alarm system LED of the motor-
cycle shows the active program-
ming step. Pressing the button
1 is confirmed by an alarm tone,
and pressing the button 2 by an
acknowledgment tone.
Step 1: is a confirmation tone
to sound after the DWA is acti-
vated/deactivated?
yes:
Press button 1.
no:
Press button 2.
Step 2:
This step is not assigned any
function.
Actuate the 1 button or 2 but-
ton.
Step 3: Which alarm tone is to
be selected?
rising and falling:
Press button 1.
intermittent:
Press button 2.
Step 4: Is the alarm function
to be automatically activated
after the ignition is switched
off?
yes:
Press button 1.
no:
Press button 2.
When is the programming
canceled?
Programming is terminated by
turning off the ignition before
the last program step, or auto-
matically whenever more than
30 seconds lapse between two
programming steps.