Start System - Honeywell R7184A Series Quick Start Manual

R7184A,B,P,U SERIES 5 INTERRUPTED ELECTRONIC OIL PRIMARY, ENVIRACOM™ ENABLED
CHECKOUT

Start System

WARNING
Fire or Explosion Hazard.
Can cause severe injury, death or property
damage.
Make sure the combustion chamber is free of oil
and/or oil vapor before starting system.
1. Open hand valve in oil supply line.
2. Make sure system is powered. Check circuit
breaker or fuse and close system switch, if
provided.
3. Set thermostat to call for heat.
4. Make sure burner lights and operates until call for
heat ends.
5. Verify that burner turns off when thermostat call for
heat is satisfied.
Check Safety Features
Safe Start
1. Place a jumper across cad cell terminals.
2. Follow procedure to turn on burner. Burner must
not start, indicator light turns on and control
remains in Idle Mode.
Simulate Flame Failure:
1. Follow procedure to turn on burner.
2. Close hand valve in oil supply line.
3. Device enters recycle mode.
4. Device tries to restart system after approximately
60 seconds.
5. Safety switch locks out approximately in safety
switch timing indicated on label. Indicator light
flashes 1/2 second on, 1/2 second off. Ignition and
motor stop and oil valve closes.
Simulate Ignition Failure:
1. Follow starting procedure to turn on burner, but do
not open oil supply hand valve.
2. Observe that safety switch locks out approximately
within safety switch timing as indicated on the
label. Indicator light flashes 1/2 second on, 1/2
second off. Ignition and motor stop and oil valve
closes.
69-1459—4
DIAGNOSTIC
LED
RESET
BUTTON
DELAY
TIME DIP
SWITCH
ALARM
TERMINALS
ENVIRACOM™
DATA PORT
CONNECTOR
ENVIRACOM™
TERMINALS
T-T TERMINALS
Fig. 2. R7184 terminals, connectors, LED, reset
button and DIP switch locations.
Fig. 3. R7184 wiring connections.
TERMINALS
Fig. 4. Alarm terminals. Press the two buttons on the
top of the terminal, insert wires, and release buttons.
4
T-T JUMPER M17822B
M17789A
WIRE RELEASE
BUTTON
M23088