Technical Information - Progress PI3550 User Manual

Problem
The appliance does not drain the water.
The anti-flood device is on.
After the checks are completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes appear, contact the
Service.
If the washing and drying results are
not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector to
a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase
or with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tablets
can be the cause. Try a different brand or

TECHNICAL INFORMATION

Dimensions
Electrical connection
Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
Activating the rinse aid dispenser with
the multitab option activated
1. Press the on/off button to activate the
2. Press and hold function buttons (B) and
3. Press function button (B).
4. Press function button (B) to change the
5. Deactivate the appliance to confirm.
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Possible solution
activate the rinse aid dispenser and use
rinse aid together with the combi deter-
gent tablets.
Refer to 'HINTS AND TIPS' for other
possible causes.
appliance. The on/off indicator comes
on. Make sure that the appliance is in
setting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
(C) at the same time until the indicators
of function buttons (A), (B) and (C) flash.
• The indicators of function buttons (A)
and (C) go off.
• The indicator of function button (B)
continues to flash.
• The end indicator is off.
setting.
• The end indicator comes on. The
rinse aid dispenser is active.
progress 25
596 / 818 - 878 / 575
220-240 V
50 Hz