Daily Use - Progress PI3550 User Manual

Filling the rinse aid dispenser
30
20
A
A
B -

DAILY USE

1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to 'SETTING
AND STARTING A PROGRAMME'.
• If the salt indicator is on, fill the salt
container.
Using the detergent
A B D
30
20
Setting and starting a programme
Setting mode
The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when, af-
ter the activation:
• All the programme indicators are on.
If the control panel shows other conditions,
press and hold function buttons (B) and (C)
at the same time until the appliance is in
setting mode.
C
+
C
1. Turn the cap (C) counterclockwise to
open the rinse aid dispenser.
2. Fill the rinse aid dispenser (A), no more
than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Put the cap in position and turn it
clockwise to close the rinse aid dis-
penser.
You can turn the selector of the re-
leased quantity (B) between position 1
(lowest quantity) and position 4 (high-
est quantity).
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme for
the type of load and the degree of soil.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
Starting a programme without delay
start
1. Open the water tap.
2. To set a programme, keep the appli-
ance door ajar.
3. Press the on/off button to activate the
appliance. The on/off indicator comes
on.
4. Make sure that the appliance is in set-
ting mode.
5. Press the button of the programme you
want to set.
progress 21