Table of Contents
Advertisement
11
PRACTICAL INFORMATION
LOAD REDUCTION MODE
System which manages the use of cer-
tain functions according to the level of
charge remaining in the battery.
When the vehicle is being driven, the
load reduction function temporarily deac-
tivates certain functions, such as the air
conditioning, the heated rear screen...
The deactivated functions are reactivat-
ed automatically as soon as conditions
permit.
System which manages the duration of
use of certain functions to conserve a
After the engine has stopped, you can
still use functions such as the audio and
telematics system, windscreen wip-
ers, dipped beam headlamps, courtesy
duration of thirty minutes.
Switching to economy mode
Once the thirty minutes are over, a
message appears on the multi-function
screen indicating that the vehicle has
switched to economy mode and the active
functions are put on standby.
194
i
If the telephone is being used at
-
it will be maintained for 10 minutes
with the hands-free kit of your
Peugeot Connect Sound,
-
it will be maintained for 10 minutes
with
the
Peugeot
Navigation
or
the
Connect Media, then it will transfer
to your telephone depending on
the telephone model.
Exiting economy mode
These functions are reactivated auto-
In order to resume the use of these
functions
immediately,
- for less than ten minutes, to use
- for more than ten minutes, to
use the equipment for up to
!
from starting (refer to the corre-
CHANGING A WIPER BLADE
Before removing a front wiper
blade
Within one minute after switching off
the ignition, operate the wiper stalk
Connect
to position the wiper blades vertically
Peugeot
on the windscreen.
Removing
Raise the corresponding wiper arm.
Unclip the wiper blade and remove it.
start
the
Fitting
Put the corresponding new wiper
blade in place and clip it.
Fold down the wiper arm carefully.
After fitting a front wiper blade
Switch on the ignition.
Operate the wiper stalk again to
park the wiper blades.
Advertisement
Table of Contents
