Set Voice Time/Day Stamp; Time Check; Greetings; Record Greeting 1 - Casio PhoneMate TA-180 Owner's Manual

PAGE
TIME/DAY STAMP
6
SET VOICE
TIME/DAY STAMP
During message playback, a synthesized voice
will announce the current time and day of the
week. To set the current time and day of the
week:
TIME SET
1
Press (under the lid).
You will hear:
Sunday
TIME
SET CHECK
SKIP/+ REPEAT/-
2
Press or until
the correct day is announced.
SKIP
REPEAT
Saturday
3
TIME SET
Press again to set the
hour. "12: " will flash in the display
and you will hear:
Enter hour.
4 SKIP/+
Press to advance or
REPEAT/-
to reverse the hour. The
hour setting will appear in the display.
GREETING 1 2
4:00
PM
5 TIME SET
Press again to set the
minutes. " :00 " will flash in the
display.
Enter
minute.
6
SKIP/+
Press to advance or
REPEAT/-
to reverse the minutes.
TIME SET
7 Press again to end. The
day and time will be announced and
time set is complete.
Saturday,
4:32 p.m.
NOTES:
If the time and day have not been set, all messages
will be stamped with " Sunday 12:00 a.m ."
When experiencing a power failure, the TA-180 will
maintain the clock function for up to 20 minutes.
After 20 minutes, the clock reverts to the factory
default setting of Sunday, 12:00 a.m., and "12:00 AM"
will flash in the display. All other stored information
including greetings and incoming messages, remote
access code, and other machine settings will be saved
and normal operation will resume when power is
restored.

TIME CHECK

In addition to the display clock, a synthesized
voice announces the time and day. Press
TIME CHECK
(under the lid.) You will hear
the current time and day setting. If the time
and day are not set, "Sunday 12:00 a.m." will
be announced.
TIME
SET CHECK

RECORDING GREETINGS

You can record one or two greetings and use
one of three greeting modes as discussed on
page 8.

RECORD GREETING 1

1 VOLUME
Adjust the
CONTROL
to about
the halfway point.
2 GREETING RECORD
Press (under
the lid). You will hear:
GREETING Press one for
greeting one. Press
two for greeting two.
RECORD CHECK SELECT
3
PLAY/PAUSE 1
Press .
PLAY/PAUSE
1
Record new
greeting one.
TIME CODE GREETING
SET CHECK SET/CHECK RECORD CHECK SELECT
CALL SCREEN MEMO
MESSAGE
CONV
PLAY/PAUSE
PLAY/PAUSE
NEW
1 & 2
ONLY
PLAYBACK
SPEED
SKIP
ERASE SAVE
REPEAT
FLASH HOLD
4
When "RECORDING" flashes in the
display, begin speaking clearly, 6-8"
away from the microphone (lower
right corner of machine). Your
greeting must be at least 3 seconds
long or the pre-recorded greeting,
" Please record a message after the
tone ," will play.
GREETING 1
12:45
PM
LINE 1 LINE 2
RECORDING
5 GREETING RECORD
Press
to end the recording. Your recorded
greeting will automatically replay.
NOTES:
The volume control does not affect the volume of the
greeting that is played to callers over the phone line. It
controls only the volume of messages played back,
greeting check and the caller's voice when using the
speakerphone.
The TA-180 indicates if no greeting has been recorded
for Greeting 1 or Greeting 2 by flashing the "1" or "2"
in the display.
LINE 1 LINE 2
ON/OFF ANNC ON/OFF ANNC
RECORD
GREETING 2
TWO LINE ALL DIGITAL
To record Greeting 2, repeat
steps 1-5 above with the
FILE
exception of pressing
PAUSE 2
in step 3.
PLAY/PAUSE
1 2
MIC
LINE 1 LINE 2
SPEAKERPHONE
PAGE
7
again
PLAY/