Table of Contents
Advertisement
PAGE
AUTODIAL
14
STORING AUTODIAL
NUMBERS INTO THE BASE
KEYPAD
You may store up to 20 of your most
frequently dialed numbers in autodial
memory (10 in the handset and 10 in the
base). The base unit must be connected to
the electrical wall outlet with the AC adapter.
The phone must be in the standby mode to
store an autodial number.
MEM
1
Press
on the base. The
STATUS INDICATOR flashes slowly.
2
Enter the telephone number you
want to store using the base keypad.
PAUSE
Use
if you want to insert a
pause in your autodial number.
3
MEM
Press
again.
4
Enter an autodial location using the
base keypad (0-9). The STATUS
INDICATOR turns off. A long
confirmation beep indicates the
number has been stored.
(cont.)
5
Continue storing autodial numbers
by repeating steps 1-4.
NOTE:
If you do not press a key within 20 seconds, the
CP-1260 will exit the programming mode.
ERASING AUTODIAL
NUMBERS FROM THE BASE
1
MEM
Press
on the base. The
STATUS INDICATOR flashes slowly.
2
MEM
Press
again.
3
Enter the memory location number
(0-9) of the number you wish to
delete. The STATUS INDICATOR
stops flashing. A long confirmation
beep indicates the number has been
erased.
USING AUTODIAL FROM
THE HANDSET
1
TALK
Press
.
2
MEM
Press
on the handset.
3
Use the handset keypad to enter the
number (0-9) corresponding to the
autodial location you wish to call. For
example, if the number of the person
you are calling is stored in autodial 6,
6
press
. The CP-1260 will
automatically dial out.
4
TALK
To hang up, press
or return the
handset to the base.
NOTE:
You must press a key within 20 seconds or the phone
will return to standby.
DEDICATED ONE TOUCH
AUTODIAL BUTTONS
Your phone is equipped with three instant
dialing buttons (M1-M3) on the handset. You
cannot store phone numbers directly into M1
to M3. These are only used to dial phone
numbers stored in handset memory locations
1-3.
M1
M2
M3
1
Press
,
or
to dial without
pressing TALK.
USING AUTODIAL FROM
THE BASE
1
SPEAKERPHONE
Press
.
2
MEM
Press
on the base.
Use the base keypad to enter the
3
number (0-9) corresponding to the
autodial location you wish to call.
For example, if you know that the
number of the person you are calling
6
is stored in autodial 6, press
. The
CP-1260 will automatically dial out
using the speakerphone.
4
To hang up, press
SPEAKERPHONE
.
PAGE
15
Advertisement
Table of Contents
