Table of Contents
Advertisement
PAGE
PAGE/INTERCOM
10
PAGING THE HANDSET
FROM THE BASE UNIT
1
To page the handset from the base
unit, in standby mode, press
INTERCOM
on the base unit. You
will hear the handset and base beep.
Move away from the base unit to
locate the handset.
2
To cancel the page, press
INTERCOM
on the base or simply
wait for the paging tone to stop within
60 seconds.
USING THE INTERCOM
FROM THE BASE UNIT
You may conduct a private conversation with
the handset user by using intercom.
INTERCOM
1
Press
on the base unit
to send a paging signal to the handset.
The handset will beep intermittently
for 60 seconds. The STATUS
INDICATOR on the base will blink.
2
When the handset user presses
INT'COM
TALK
or
, the handset and
the base unit will be connected.
3
To terminate the intercom call, press
TALK
on the handset or
SPEAKERPHONE
on the base unit.
USING THE INTERCOM
FROM THE HANDSET
In the standby mode, press
1
INT'COM
to send a paging signal to
the base unit user. Both the handset
and base will beep.
2
When the base user presses
INTERCOM
SPEAKERPHONE
or
the handset and the base unit will be
connected.
3
TALK
Press
on the handset or
SPEAKERPHONE
on the base to
terminate the intercom mode.
NOTES:
Intercom can also be activated during a
conversation to allow the handset user and base
user to speak privately while the caller is on hold.
To activate a 3-way conference call between the
caller, the handset user and the base
speakerphone user during an active call, see "3-
WAY CONFERENCE" on page 12.
You can attempt an intercom connection for
maximum 1 minute. It stops if no one answers.
ANSWERING A CALL WHILE
USING THE INTERCOM
If you receive an incoming call during an
intercom conversation you will hear a ring
through the base speaker.
SPEAKERPHONE
1
Press
the intercom conversation and press
SPEAKERPHONE
again to answer
the incoming call. The handset is
automatically disconnected from the
intercom.
,
2
Speak to the caller.
SPEAKERPHONE
3
Press
hang up.
OR
1
TALK
Press
on the handset to hang
up the intercom conversation and
TALK
press
again to answer the
incoming call with the handset. The
base unit is automatically
disconnected from the intercom.
2
Speak to the caller.
3
TALK
Press
again to hang up.
ROOM MONITOR
You can call your base unit from the handset
and monitor sounds in the room where your
base unit is installed.
INT'COM
1
Press
to hang up
The handset beeps.
2
TALK
Press
. You hear sounds in the
room where your base unit is
installed.
3
To finish the room monitor, press
TALK
again.
again to
PAGE
11
on the handset.
Advertisement
Table of Contents
