Table of Contents
Advertisement
IMPORTANT SAFETY
PAGE
2
INSTRUCTIONS
INSTALLATION INSTRUCTIONS
1.
Never install telephone wiring during a lightning storm.
2.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
3.
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the
network interface.
4.
Use caution when installing or modifying telephone lines.
SAFETY PRECAUTIONS
When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of
fire, electric shock and injury to persons, including the following:
1.
Read and understand all instructions.
2.
Follow all warnings and instructions marked on the product.
3.
Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use
a damp cloth for cleaning.
4.
Do not use this product near water: for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in
a wet basement, or near a swimming pool.
5.
Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious product
damage.
6.
Slots and openings in the cabinet and the back or bottom are provided for ventilation. To protect it from
overheating, these openings must not be blocked or covered by placing the product on the bed, sofa, rug, or
other similar surface. This product should never be placed near or over a radiator or heat register. This
product should not be placed in an enclosed environment unless proper ventilation is provided.
7.
Do not allow anything to rest on the power cord. Do not locate this product where the cord will be abused by
animals or persons walking on it.
8.
Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.
9.
Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage
points or short out parts that could result in a risk of fire or electric shock.
10. Never spill liquid of any kind on the product.
11. To reduce the risk of electric shock, do not disassemble this product. Take it to a qualified service person
when service or repair work is required. Opening or removing covers may expose you to dangerous voltages
or other risks. Incorrect re-assembly can cause electric shock when the appliance is subsequently used.
12. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the
following conditions:
A.
When the power supply cord or plug is damaged or frayed.
B.
If liquid has been spilled into the product.
C.
If the product has been exposed to rain or water.
D.
If the product does not operate normally by following the operating instructions. Adjust only those
controls that are covered by the operating instructions because improper adjustment of other controls
may result in damage and will often require extensive work by a qualified technician to restore the
product to normal operation.
E.
If the product has been dropped or the cabinet has been damaged.
F.
If the product exhibits a distinct change in performance.
13. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk
of electric shock from lightning.
14. Do not use the telephone to report a gas leak while near the leak.
15. You should use ONLY the power adapter supplied with the unit. If you need a replacement, please see
ACCESSORIES on page 25 to place an order.
SAVE THESE INSTRUCTIONS
INSTALLATION
CONNECTING YOUR UNIT
1
Install the handset battery. See page 19,
"HANDSET BATTERY INSTALLATION."
PLUG
2
the CP-1260's telephone cord into a
PLUG
telephone wall jack.
the cord into the back of the base unit.
CONNECT
3
the AC Adapter Plug into the DC IN 9V jack on the back
ROUTE
of the unit.
the cord around the strain relief latch (on the
underside of the unit) to prevent accidental disconnection.
4
PLUG
the AC Adapter into an
electrical wall outlet.
5
It may be necessary to set the TONE/
PULSE SWITCH (see page 4).
6
Raise the charging cradle antenna for
clear reception.
7
Place the handset (with battery pack
installed) in the cradle and charge for
12-15 hours.
NOTES:
Place the power cord so it does not create a trip hazard, or where it could become chafed and create a fire or electrical
hazard.
Use only the supplied AC Adapter, do not use any other AC adapters.
the other end of
PAGE
3
Advertisement
Table of Contents
