Advertisement
Step 3: Mounting the front frame and the cover panel
1. Mount the front frame with the tapping screws included in the delivery (fig. 3).
2. Place the cover panel on top of the back wall and the side panels. Ensure that the side with
the 8 holes of the cover panel is facing upward (fig. 4).
3. Attach the two dividers in the centre piece via the tapping screws (fig. 5).
Step 3 / Fig. 3
Step 4: Mounting the doors
1. Place the lower door hinge into the hole in the rail. Then place a plastic washer on top of it
(fig. 6b).
2. Place the door onto the lower hinge (fig. 6).
3. Then adjust the door, ensure that the top hole of the door matches up with that of the cover
panel.
Step 3 / Fig. 5
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Step 4 / Fig. 6b
Item 60237, 60238
Step 3 / Fig. 4
Step 4 / Fig. 6
Page 8
01
2021-1
Advertisement
