Advertisement
Step 11: Mounting the worktop
1. Finally mount the work surface onto the frame. On each side of the frame there are three
holes, which are used to connect the frame with the work surface via tapping screws.
2. The drawer can then be mounted beneath the work surface (fig. 17).
Cleaning and care
Clean the cabinet with a neutral cleaning detergent. Do not use any acidic or abrasive clean-
ing detergents or sponges. These might damage the cabinet.
Do not expose the cabinet to any weathering influences, as it can have a negative impact on
the surface of the cabinet and its durability.
Clean the cabinet with the a damp, soft cloth and wipe it afterwards with a clean dry cloth.
Important notice:
The reprint or reproduction, even of excerpts, and any commercial use, even in part of this instructions
manual require the written permission of WilTec Wildanger Technik GmbH.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Step 11 / Fig. 17
Item 60237, 60238
Page 12
01
2021-1
Advertisement
