Configuration and setup
Furthermore, you can also use CLI interface through Console port/Telnet/SSH to configure wienet
SDS. Enable the Access Control (refer to System Setup > Admin Settings), then you can use CLI in-
terface.
Figure 6: Access control
Note that if you change the IP address, you need to restart wienet SDS.
N OT I C E
Configuring automatic IP assignment with DHCP
A DHCP server can automatically assign IP addresses, Subnet Mask and Network Gateway to LAN in-
terface. You can simply check the DHCP (Obtain an IP Automatically) checkbox in the Network Set-
ting dialog using Wieland's wienet Manager, a device management utility, and then restart the de-
vice. Once restarted, the IP address will be configured automatically.
Wieland Electric GmbH | BA000870 | 06/2020 (Rev. A)
13