Battery Installation - Global Water Water Box Operation Manual

care is not exercised.
PORCELAIN ENAMEL SINK/ STAINLESS STEEL SINK/ ALUMIUM SINK
A 5/8" hole is required for the faucet. It is recommended that you get
special drill bit for porcelain and tile counter.
1. Place a piece of masking tape or duct tape on the determined
location where the hole is to be drilled.
2. Use a variable speed drill at slow speed with 1/8" drill bit, and drill a
centering hole in the center of the desired faucet location.
3. Enlarge the hole using a 1/ 4" drill bit.
4. Enlarge the hole using 7/16", 1/ 2", and 5/8" drill bit. Pause
occasionally to cool the drill bit.
5. File or clean the surrounding area and remove the masking or duct
tape. (NOTE: the metal chips on porcelain will stain very fast)
6. DON'T put Teflon tape at the tip of the threaded mounting base of
the faucet since it's a compression fitting.
7. Put the small rubber washer, the chrome base plate, large rubber
washer according to the diagram through the threaded mounting tube
at the base of the faucet.
8. From under the sink, install the bottom plate, lock washer, and nut.
Then screw on tightly.
9. According to the diagram, put the brass nut through the BLUE tubing
first, then plastic sleeve (preferred), or brass sleeve, then the plastic
insert. Push the white plastic sleeve against the insert.
10. Screw on the Blue tubing with brass nut to the faucet base. Uses
wrench to tighten the nut but don't over tighten it. Too tight would
cause leak.
11. The spout can swivel 360-degrees. The faucet lever can be pushed
down for dispensing or pulled up for continuing dispensing

Battery Installation

To install the batteries simply unscrew the top cover of the water box.
The 2 screws are located in the back of the Water Box on the top cover.
Install the batteries and LED light will illuminate.
9 | P a g e