Common Fault And The Processing Method - Joy Sport Life Fit Manual

ⅩCOMMON FAULT AND THE PROCESSING METHOD

Fault Symptom
Either turning on or turning
off the switch power, the
treadmill can not display
when we the electric power
is connected.
All the display windows
flicker.
It stops by itself when it is
working. And all the
displays are normal.
The running belt can not
work normally, and it has
buzz, with displaying
normally.
It is regular when it is
running by itself ,and
disordered when someone
walking on it.
It can not display normally
or can not display.
Because of some reasons, the technical parameter may has a little difference. So we
can not take it as criterion to measure our state of health, all the data is just as a
reference.
Please cut off the power immediately and contact with our agents when there is
special fault symptom. We will provide you the best service in time.
Possible Causes
1. The attaching plug is
not inserted well. 2 .The
electrical head‟s
attaching plug is not
inserted well. 3. The
tube fuse is destroyed.
The safety switch is not
settled well or damaged.
The automatic system
protection.
The enter voltage is too
low.
Check whether the
running belt is too loose.
The electrical head can
not work because of the
external disturbance .
Solution
1. Insert it again. 2.
Connect it once
more. 3. Change the
tube fuse.
Put the safety switch
on the correct place
or mend it.
1. Press the „STOP‟
key, then start it. 2
.Turn off the power
switch, and start it in
one minute.
Use it when the
voltage return to
normal.
Please adjust the
running belt
according to the right
method.
Turn off the power
switch, then turn on
it in one minute.