JETI model SPIN 11 Manual page 6

P
Brake OFF
If during initial selection we choose BRAKE OFF then we proceed further from the line
OPERATION MODE AIRCRAFT with push-button P for the Heli mode setting.
P
Operation mode
Aircraft
D
Redefined brake:
The first value is the initial braking level in %, the second value – the
final braking level in %, the third value – time of brake application
between the first and second intensity. Confirm brake setting with
push-button D.
If the brake is switched off jump to line OPERATION MODE –
switching between modes Aircraft-Helicopter.
P
Soft Brake
Initial braking level in %.By means of push-buttons
Speed of braking (time between the begin of braking
and attainment of the preset final braking effekt).
Setting for model helicopters
without constant speed
regulation
Heli normal
Setting by (L-P) of the min. required rotor rpm.
We recommend to set the value to 1000 – 1500 rpm
6
P
Medium Brake
Time from motor cut-off until
brake activation. By means of push-buttons
L-P setting between 0-7s is possible.
L-P setting between 0-80% is
possible
Final braking level in %.
Setting by push-buttons L-P
The time is set by push-buttons L-P
Setting for model helicopters
with speed regulation
P
Heli const.
RPM
Setting of motor pole numbers
of Helicopters by means of
push-buttons L-P
Setting by (L-P) of the total gear
ratio of the main rotor
Setting by (L-P) of the max. required
P
Brake Manual
Hard Brake
Jump to position
Setting for competition
flying with constant speed
P
D
Motor Pole No
Set Max Rotor
rotor rpm
Set Min Rotor
Setting
D
Dead Time
D
Initial Brake
D
Final Brake
D
Brake Speed
D
TIMING
regulation
Heli const.
RPM 3D
D
D
Gear
D
RPM
D
RPM