Setting with the help of the R/C equipment
- connect the controller by means of the JR connector to the receiver throttle channel and connect the motor.
- shift the throttle stick to position „full throttle", switch on the transmitter and connect the flight batteries.
- switch on the switch (void for SPIN 11), after five seconds four tones sound ♪♪♫♪. If the throttle stick is immediately
shifted back to low throttle position the value of the full throttle position is stored in the memory (END POINT),
otherways follows:
♪ single tones - mode 1 Acro inrunner:
classic
♪♪ two tones - mode 2 Acro outrunner:
♪♪♪ groups of three tones - mode 3 Glider inrunner:- this mode is appointed to gliders driven by motors of classic
♪♪ ♪♪ groups of four tones - mode 4 Glider outrunner: - this mode is appointed to gliders driven by motors of the
♪♪ ♪♪♪ groups of five tones - mode 5 Heli constant RPM:
♪♪ ♪♪ ♪♪ groups of six tones - mode 6 Heli constant RPM (3D):
constant speed regulation along with fast changes
Confirmation of the setting is carried out by shifting back the throttle to low throttle position during the tone signals of
the factual mode.
3
- this mode is appointed to aerobatic models driven by motors of
conception. (inrunner)
- brake not active
- timing 0°
- gradual switching off when 68% of the starting voltage is reached.
- this mode is appointed to aerobatic models driven by motors of
the reversed conception. (outrunner)
- brake not active
- timing 24°
- gradual switching off when 68% of the starting voltage is reached.
conception. (inrunner)
- brake activated
- timung 0°
- gradual switching off when 68% of the starting voltage is reached.
reversed conception. (outrunner)
- brake activated
- timing 24°
- gradual switching off when 68% of the starting voltage is
reached.
- this mode is appointed to model helicopters with the claim
for constant speed regulation with changing load/unload of the
rotor. This mode does not support fast speed changes
- timing 0°
- gradual switching off when 68% of the starting voltage is reached.
- this mode is appointed to model helicopters with the claim
- timing 0°
- gradual switching off when 68% of the starting voltage is reached.
for
Need help?
Do you have a question about the SPIN 11 and is the answer not in the manual?