Siemens RDS110 User Manual page 31

Dehumidification
setpoints
A6V10877569_en--_e
No. Application Descriptions
settings
20. Comfort The dehumidification
dehum. setpoint for "Comfort".
setpoint This setpoint must be
lower than the
dehumidification
setpoint for protection.
21. Economy The dehumidification
dehum. setpoint for
setpoint "Economy". This
setpoint must be lower
than the
dehumidification
setpoint for protection.
22. Unoccupied The dehumidification
dehum. setpoint for
setpoint "Unoccupied". This
setpoint must be lower
than the
dehumidification
setpoint for protection.
23. Protection The dehumidification
dehum. setpoint to maintain
setpoint when you switch the
thermostat to "OFF"
under
mode". This setpoint
must be lower than the
dehumidification
setpoint for protection.
NOTE: Dehumidification control works with a PID algorithm. The algorithm
continuously monitors the difference between the humidity setpoint for
dehumidification and the measured relative air humidity in the room and switches
the dehumidifier ON and OFF to keep the room humidity below the setpoint. The
dehumidifier cannot manually be switched on and off. Changes to the setpoint
impact dehumidification control, thereby verifying functionality.
Operating the thermostat on the device
Factory
settings
60%RH 0...100%RH Displays only if
60%RH 0...100%RH
70%RH 0...100%RH
70%RH 0...100%RH This setting
> "Operating
Advanced settings
Range Dependencies
you've
configured the
output as
"Dehumidifier
(no fan)".
displays only if
you've
configured the
output as
"Dehumidifier
(no fan)".
This setpoint is
valid only if you
keep the
default
Protection
option for
Application
setting No. 37.
31 | 59
6