Bolting Down The Ms500 - Nautilus Hyosung MS500 Installation Manual

Installation Manual

Bolting Down the MS500

► To bolt down the MS500 using the Anchor Bolt Location Sheet (template), perform the
following steps:
1. Ensure that the surface where the MS500 is to be placed is level so that the unit
will not tip over when opening the upper/lower modules or the door.
2. Place the anchor bolt location sheet where the MS500 is to be installed.
3. Drill the correct diameter and depth holes at the locations marked on the sheet.
4. With the groove of the anchor bolt facing up, drive the anchors into the holes
drilled in step 3.
5. Place the MS500 on the bolt location sheet, matching the mounting holes of the
unit with the anchors.
6. Firmly tighten the mounting bolts in the anchors.
© 2016 Nautilus Hyosung Inc. All Rights Reserved.
Chapter4. System Installation
4-2