Advertisement
Note: When fitting/refitting the licence plate to the vehicle, ensure there is no obstruction to licence plate vision in
accordance with local authorities. If required relocate licence plate to an alternate location.
Further VFPS Notes:
a) Do not attach VFPS to the vehicle using anchorages not intended for this purpose (e.g. engine mounting bolts).
b) Do not use this product for any vehicle make or model, other than those specified by the VFPS manufacturer.
c) Do not remove the plaque or label from the VFPS.
d) Do not modify the structure of the VFPS in any way.
e) No accessory or fitment should project forward of the VFPS forward profile.
f) ENSURE THESE INSTRUCTIONS ARE LEFT WITH VEHICLE OWNER AND/OR OPERATOR.
Periodically check bolts and nuts for correct tightness, especially if travelling on rough roads
FITTING KIT
1 – Winch mounting plate.
1 – Control box bracket.
2 – Steel mounting brackets.
2 – 40mm alloy washers c/w 13mm round holes.
4 – M10 x 30 x 1.25 bolts.
4 – 3/8 x 1 ¼ bolts and nuts.
16 – 3/8 flat washers.
8 – 3/8 spring washers.
2 – ½ x 6 bolts and nuts.
3 plastic clips
Figure 1
.
IMPORTANT INFORMATION
8 – ½ spring washers.
4 – ½ x 1 ½ bolts and nuts.
2 – ½ x 1 ¾ bolts.
16 – ½ flat washers.
1 – ECB LED Indicator / Park light kit
6 – Cable locks.
1 – 2500mm length 6mm black infill trim.
2 – 200mm lengths 6mm black clip lock.
2 – Round cut out surrounds.
© Copyright – ECB Pty Ltd – 2010
Attach 6mm black clip lock to each side of
roller fairlead cut out
Figure 2
3
Advertisement
