Installing The Copier; Checking The Package Contents; Installation Procedure - Canon PC140 Operator's Manual

Installing the Installing the
Copier Copier
Checking the Package
Contents
1
Remove the copier and the
accessories from the shipping
box. Use the following checklist
to make sure you have received
all the necessary accessories
included with your copier.
Item
Registration Card
Power Cord
Operator's Manual
Cartridge
Muliti-stack tray
Copy tray
18
01/ PC140-USA

Installation Procedure

Before installing the copier be
sure to check the safety of the
power source. Then proceed with
the following procedure.
Although the starter cartridge
comes already installed in the
main unit, it is necessary to
remove the sealing tape from the
cartridge before use.
The cartridge cannot be used if
the seal is not removed.
(See "Installation Precautions",
Quantity
on p. 11 and "Replacing and
Storing Cartridges", on p. 19.)
1
1
1
Remove the copier from its shipping bag
1
and gently remove all the packing tape
attached to the copier.
1
1
18
Slightly slide the copy tray and the multi-
stack tray out from the opening between
the disc and the platen cover, and then
open the trays fully.
Slide the platen to the left, press the top
cover release button and lift open the top
cover. Grip the end of the cartridge, and
pull it out of the copier.
(See "Replacing and Storing Cartridges",
on p. 19.)
Hold the cartridge level so that the side
with the written instructions is facing
upward.
10/10/03, 7:35 AM