Operating Range; Remote Control Unit Battery Installation - Canon LV-S2 Owner's Manual

Point Remote Control Unit toward projector (Receiver
Window) whenever pressing any button. Maximum
operating range for Remote Control Unit is about 16.4' (5m)
and 60° in front of the projector.

REMOTE CONTROL UNIT BATTERY INSTALLATION

1
Pull out Battery Holder.
To insure safe operation, please observe the following precautions :
G Use only specified battery. Improper battery may cause malfunction of Remote Control Unit.
G Be sure to install battery with correct polarity.
G Do not expose a battery to moisture or heat. Do not charge a battery.
G If a battery has leaked on the Remote Control Unit, carefully wipe the case clean and load a new battery.
G Keep a battery away from children to avoid swallowing it accidentally.
G Risk of explosion if battery is replaced by an incorrect type.
G Dispose of used batteries according to the instructions.

OPERATING RANGE

Replace with new battery. Install
2
with battery (+),(–) marks properly.
Put Battery + mark
as shown direction.
BATTERY HOLDER
16.4'
(5 m)
30°
30°
Install battery and
3
Battery Holder into
Remote Control Unit.
BATTERY
LITHIUM BATTERY
CR2025 (3.0V)
BEFORE OPERATION
(+) mark indicates
its (+) polarity.
15