Makita MU02 Instruction Manual page 15

1
► 1. Trimming direction 2. Tilt the blades 3. Hedge
surface to be trimmed
As a basic operation, tilt the blades towards the trim-
ming direction and move it calmly and slowly at the
speed rate of 3 - 4 seconds per meter.
► 1. String
To cut a hedge top evenly, it helps to tie a string at the
desired hedge height and to trim along it, using it as a
reference line.
Attaching the chip receiver (optional accessory) on the
tool when trimming the hedge straight can avoid cut off
leaves' being thrown away.
2
3
1
To cut a hedge side evenly, it helps to cut from the
bottom upwards.
Trim boxwood or rhododendron from the base toward
the top for a nice appearance and good job.
Installing or removing chip receiver
(optional accessory)
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before installing
or removing chip receiver.
NOTE:
• When replacing the chip receiver, always wear
gloves so that hands and face does not directly
contact the blade. Failure to do so may cause
personal injury.
• When replacing the chip receiver, always be
careful not to contact the shear blades.
• The chip receiver receives cut-off leaves and
alleviates collecting thrown-away leaves. This
can be installed on either side of the tool.
15 ENGLISH