Sanyo CE21DN6F-C Instruction Manual page 5

GB
Programme Selection
Direct Programme Selection
For selection of programme position 0 to 9, press the corresponding
numeric button. If the required programme is equal or more than
10, for example 23, first press the -/- - button and enter 2 then 3.
Up/Down Programme Selection
Press the P button to increase the programme position.
Press the P button to decrease the programme position.
Sound & Picture settings
1. To adjust the sound volume, press the
2. Each time the /OK button is pressed, the function display
changes as illustrated.
Picture Controls
CONTRAST : To adjust the picture contrast.
BRIGHTNESS : To adjust the picture brightness.
COLOUR : To adjust the picture colour.
SHARPNESS : To adjust the picture sharpness.
TINT: To adjust the colour phase (appears when receiving a
NTSC signal only).
TEXT BRIGHTNESS : To select the teletext brightness level of the
teletext mode.
< >
FINE TUNING : To make fine adjustments to tuning.
Sound Controls
BASS : To adjust low frequency sounds.
TREBLE : To adjust high frequency sounds.
BALANCE : To equalise the output from the left and right speakers.
CONTRAST
BALANCE
TREBLE
BASS
3. To adjust the level of the selected function, press the
/ button.
Sound Attenuation
This function has two sound mute stages. Press the
the sound from the speakers will be reduced, press it again and it will
be muted completely.
Press the button again to switch the sound back on.
When the / button is pressed, the sound attenuation is
cancelled.
GENERAL OPERA
GENERAL OPERA
/ button.
SOUND
BRIGHTNESS
COLOUR
SHARPNESS
TEXT BRIGHTNESS
CENTRE
FINE TUNING
button once,
SOUND MUTE
TION
TION
Channel Selection
If you know the channel number of the station
1. Press the CS button on the remote control handset. The current
channel number, programme position and channel ID if available
will be displayed on the screen.
2. Enter the channel number using the 0-9 numeric buttons.
For example: To enter channel number 2 enter 0 and 2.
To enter channel number 35 enter 3 and 5.
If you wish to select hyper channel, select "H--" by pressing the CS
button. Then enter the hyper channel number. Each time the CS
button is pressed, the channel number changes as follows.
current channel number normal channel mode
mode
Please refer to channel table on page 16 for further information of
channel allocation.
3. While the screen display is still on the screen, press the
button on the remote control handset.
The programme and channel number will momentarily flash.
Channel number
C25
H35
Hyper band channel number
Programme number Sound system
If you do not know the channel number of the station
1. Press the CS button on the remote control handset. The current
channel number, programme position and channel ID if available
will be displayed on the screen.
2. Press the P or P button to start channel searching. When a
station is found searching stops automatically.
If this is not desired station repeat until the desired station is found.
3. While the screen display is still on the screen, press the
button on the remote control handset.
The programme and channel number will momentarily flash.
Selection of the sound system
If the sound which is being received for the station is not produced, or is
of poor quality, even though the picture is good, it may select the incor-
rect sound system.
To switch the sound system, press the
the screen display is still on the screen. The sound system will switch as
follows:
S-1 (AUTO) -> S-2 (B/G) -> S-3 (I) -> S-4 (L/L')
S-1 : AUTO
S-2 : B/G
S-3 : I
S-4 : France SECAM-L/L'
GB
hyper channel
/OK
3
S-1
/OK
button repeatedly while
5