Connecting To A Power Source; Figure 17: Power Inlet - LG-Nortel iPECS ES-3026 Installation Manual

C P
ONNECTING TO A
The SFP slots support the following optional SFP transceivers:
1000BASE-SX
■
1000BASE-LX
■
1000BASE-LH
■
100BASE-FX
■
To install an SFP transceiver, do the following:
Consider network and cabling requirements to select an appropriate
1.
SFP transceiver type.
Insert the transceiver with the optical connector facing outward and the
2.
slot connector facing down. Note that SFP transceivers are keyed so
they can only be installed in one orientation.
Slide the SFP transceiver into the slot until it clicks into place.
3.
SFP transceivers are hot-swappable. The switch does not need to be
N :
OTE
powered off before installing or removing the transceiver. However, always
first disconnect the network cable before removing the transceiver.
SFP transceivers are not provided in the switch package.
N :
OTE
S
OWER OURCE
To connect a switch to a power source:
Insert the power cable plug directly into the AC inlet located at the back
1.
of the switch.

Figure 17: Power Inlet

Plug the other end of the cable into a grounded, 3-pin, AC power
2.
source.
– 33 –
| Installing the Switch
C 3
HAPTER

Connecting to a Power Source

ES-3026/3026P
AC 100-240V, 50-60Hz, 3A