Nokia HA-0236G-A Product Manual page 35

Nokia WiFi HA-0236G-A Extender Product Guide
Procedure 6
Issue 01
Installation procedure
1 Place the unit on a flat surface, such as the base included, a desk or shelf.
Note 1 — The HA-0236G-A extender cannot be stacked with another
extender or with other equipment. The installation requirements are:
•
allow a minimum 100 mm clearance above the top cover
•
allow a minimum 50 mm clearance from the side vents
•
do not place any heat source directly above the top cover or below the
bottom cover
Note 2 — The Wi-Fi coverage between the RGW and the HA-0236G-A
extender must overlap the Wi-Fi/Ethernet signal to configure Easy Mesh
seamlessly. The number of HA-0236G-A extender(s) needed depends on
the size of area that needs access.
2 Review the connection locations, as shown in Figure 3.
3 Connect the Ethernet cable to the RJ-45 port; see Figure
4 Connect the power cable to the power connector.
Note — Units must be powered by a Listed power supply with a
minimum output rate of 12 V dc, 2A. The polarity of the power adapter
plug must match the extender.
5 Power up the unit by using the On/Off power switch.
6 Verify the LED, which indicates WiFi backhaul quality. See
LEDs
for the LED description.
3FE-48251-AAAA-TCZZA
ChapterTitleVariable
3 for the location of the RJ-45 port.
4.5HA-0236G-A extender
35