Safety Standards Compliance; Emc, Emi, And Esd Standards Compliance; Figure 1 Sample Safety Label - Nokia HA-0236G-A Product Manual

Nokia WiFi HA-0236G-A Extender Product Guide

2.2 Safety standards compliance

2.2.1
Issue 01
Sample safety label
Figure 1
This section describesthe extender compliance with North American safety
standards.
Warning —
approved by the party responsible for compliance could void
the user's authority to operate the equipment.

EMC, EMI, and ESD standards compliance

The customer premises equipment complies with the following requirements:
•
Federal Communications Commission (FCC) CFR 47, Part 15, Subpart B, Class
B requirements for equipment
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
3FE-48251-AAAA-TCZZA
Changes or modifications to this unit not expressly
ChapterTitleVariable
17