Cleaning And Storage - MAXXMEE IM21OOT-GS Manual

EN
1. Completely unwind the connecting
cable and plug it into a plug socket
that is easily accessible. The light for
the set ice cube size (11 or 12) lights
up and the POWER light (17) fl ashes.
2. If necessary, change the ice cube size
by pressing the SELECT button (14).
3. Start making the ice cubes by pressing
the ON / OFF button (10). The POWER
light is constantly lit. The device initially
pumps the water through the cooling
rods once in order to cool down the
water and then starts making the ice
cubes.
The device keeps operating until
○ the ice cube container (7) is full (ICE
FULL light (15) is lit);
○ the water tank (6) is empty (ADD
WATER light (16) is lit);
○ the production process is stopped
by pressing the ON / OFF button.
Once the ice cube container is emp-
tied, the ICE FULL light goes out and
the device automatically starts the
production process again.
Once the water tank is topped up, the
ADD WATER light goes out. The pro-
duction process needs to be restarted
by pressing the ON / OFF button.
 
If the production process is not
started manually after the water
has been topped up, the device
starts automatically after 20 min-
utes.
4. If the device is no longer going to be
used, pull the mains plug out of the
plug socket.
Drain any remaining water from the
device after every use (see the "Cleaning
and Storage" chapter).
16
02031_Inlay_DE-EN-FR-NL_A5_V1.indb 16 02031_Inlay_DE-EN-FR-NL_A5_V1.indb 16

CLEANING AND STORAGE

Please Note!
■
Allow the device to warm up to room
temperature before it is cleaned.
■
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. These may damage
the surfaces.
• Make sure that the device is not con-
nected to the mains power.
• Drain the rest of the water from the
device:
○ Pull the device over the edge of
the surface it is resting on until it is
protruding by approx. 6 cm.
○ Hold a vessel with a suffi cient ca-
pacity below the protruding device
and pull out the drain plug (5) on
the bottom of the device.
○ Allow all of the water to drain out.
○ Insert the drain plug all the way
back in the device.
• Clean the ice cube container (7) with
warm water and a little detergent if
necessary.
• If necessary, wipe down the housing
with a damp cloth. If there is heavy
soiling, use a little detergent if nec-
essary.
• Thoroughly wipe down the device
(inside and outside) and the ice cube
container with a dry cloth.
• Store the device in a dry, clean, frost-
free place that is protected from di-
rect sunlight and cannot be accessed
by children or animals.
19.11.2020 13:18:26 19.11.2020 13:18:26