Functions; Before Initial Use; Preparation; Use - MAXXMEE IM21OOT-GS Manual

Ice Cube Maker

FUNCTIONS

The device can produce ice cubes in
two different sizes and has a cleaning
programme.
ON / OFF (10)
S (Small) (11)
L (Large) (12)
CLEAN (13)
SELECT (14)
ICE FULL (15)
ADD WATER (16) Fill the water tank
POWER (17)

BEFORE INITIAL USE

There may still be some production
residues on the device. To avoid harmful
effects to your health, clean the device
thoroughly before you fi rst use it (see
"Cleaning and Storage").

PREPARATION

Please Note!
■
The surfaces of furniture may possibly
contain elements which can attack
and soften the adjustable feet of the
device. If necessary, place a suitable
pad below the adjustable feet.
■
Check that the fi lter fi ts securely in the
water tank. If chunks of ice get into
the water system, the device could be
damaged.
■
Never overfi ll the water tank (note the
MAX marking)! Water could overfl ow
and damage the device.
■
Never pour any warm water into the
water tank to prevent damage to the
device.
02031_Inlay_DE-EN-FR-NL_A5_V1.indb 15 02031_Inlay_DE-EN-FR-NL_A5_V1.indb 15
Start / stop programme
Small ice cubes
Large ice cubes
Cleaning programme
Select programme
(S – L – CLEAN)
Ice container full
Lit up: operating
Flashing: on standby
IMPORTANT! Once you have transported
and set up the device, the device needs
to rest for approx. 30 minutes so that the
liquid in the cooling system can settle!
Before you fi rst use the device, it should
rest for approx. 2 hours before it is used.
1. Make sure that the drain plug (5)
is fully fi tted on the bottom of the
device.
2. Always set up the device with a clear
space at the sides (at least 20 cm) and
clear space above it (at least 30 cm)
on a fl at, solid, heat-resistant and
resilient surface.
3. Open up the lid (8) and fi ll the water
tank (6) with water using a measuring
cup or similar vessel. Note the MAX
marking when you do this!
4. Insert the ice cube container (7) into
the device.
5. Flip the lid shut.

USE

Please Note!
■
Only connect the device to a plug
socket that is properly installed. The
plug socket must also be readily
accessible after connection so that the
connection to the mains can quickly
be isolated. The mains voltage must
match the technical data of the device.
■
Lay the connecting cable so that it is
not squashed, bent or laid over sharp
edges and does not come into con-
tact with hot surfaces.
IMPORTANT! The cooling system of the
device is operated by a compressor (4).
It is normal for the compressor and the
cooling liquid in the refrigerant circuit to
make noises. The noises are louder when
you start using the device; they reduce as
you use the device more.
EN
15
19.11.2020 13:18:26 19.11.2020 13:18:26