Page 2
Notes for using Checklist before riding E-Scooter and E-Bike laws differ by State - check your local laws and only ride in legally permitted areas. ■ The power circuit and lighting are working. ■ The front and rear brake lever are working. Use helmets, protective gear and always ride responsibly.
Get to know C26 quickly How to install battery: 1.Insert the key into battery lock and turn to unlock. 2. Place battery into the battery slot as shown on diagram 1, push battery upward until you hear a clear sound and the battery is powering the bike.
Display and riding mode Display introduction Mode button Switch button Speed Mileage accumulated (switching) Subtotal mileage Headlight indication (switching) loon Uu.o HIMO km/h Power indicator DODOO UUUU. U ™ Trip (ill G:::::8) - : � C� Gear position indication (power/medium speed/high speed)
Page 6
• Normal riding • Electric assist riding • - • n Long press the button (.!) for 3 seconds to start the : • Long press the key (.!) for 3 seconds to HIM0 riJ/1 � electric bike; close the electric bike; •...
Page 7
Switch for the headlight ■ Long press button for 3 second to open the headlight ■ Long press button for 3 second to close the headlight ■ • Mileage pattern ■ In the startup state; ■ Press button to switch between (TRIP) --+ ,IUllill accumulated mileage (ODO) I�...
Battery charging How to charge: Charger ■ IMPORTANT: connect the charger to the charging port of the battery first, then connect the charger to power supply. ■ When charging, the indicator light on charger is red, and it will turn green when fully charged. Power supply pin Soft cap ■...
Check battery capacity Press the power display button to display the current remaining power _ P _ o _ w _ e _ r _i n _ d _ i _ c a _ t _ o _ -+ ---+-i Power indicator___ 100% 75% 40% 10% Change battery...
Page 10
■ ■ ■ Gears Understand the gears Gear Power Speed Gear indicator Rlax Slow 4 - 5 Moderate Moderate 6 - 7 Hard Fast To speed up, start with a lower gear and shift to a higher gear as you speed up ■...
Page 11
Damping When to use shock absorber system: 1.Open shock absorber for bumpy road. 2.Close shock absorber for even ground, long travels or uphill. No closing the shock absorber will make riding more difficult on good road condition. 3. Shock absorbers can be fine-tuned, along the direction of the arrow indicated in diagram 3.
■ ■ ■ ■ About batteries Instruction on lithium battery Only use original battery of the bike, never use non-authentic battery or battery of any other brands. Before use, ensure lithium battery is intact, there is no damage, fluid leakage, overheating, smoke and other abnormality. Please charge the battery before first use.
■ ■ ■ Charger port of the battery Only use the original charger to charge the b attery. Do not use other brand or other model charger to charge the battery. ■ Please charge the battery at the ambient temperature of 10 C - 40 C with good ventilation, stay away from any flammable ■...
Maintenance and repair Regular bike inspection check if pairs are fastened and all the joints of parts are in good condition ■ check if tire is worn and cracked, if tire pressure is appropriate, if the power system is working well ■...
Troubleshooting Problems Reasons for the problem Solution way When the power is turned on Bike is not powered 1.Check whether the battery is properly inserted and the bike can not be 2.Charge the battery powered on 1.The bike is in the brake status 1.Whether the brake lever is on the brake Turn on the power and the 2.Pedal to 5km/h...
Need help?
Do you have a question about the C26 and is the answer not in the manual?
Questions and answers