Maytag 4KMEDC100 Use And Care Manual page 11

TROUBLESHOOTING (cont.)
If you experience
Cycle time too short
Lint on load
Stains on load or drum
Loads are wrinkled
Odors
Load is too hot
First try the solutions suggested here to possibly avoid the cost of a service call.
Possible Causes
Automatic cycle ending early.
Lint screen clogged.
Dryer fabric softener not properly
used.
Load not removed from dryer at the
end of the cycle.
Dryer tightly packed.
You have recently been painting,
staining, or varnishing in the area
where your dryer is located.
The electric dryer is being used for
the first time.
Laundry items were removed from
the dryer before the end of the cycle.
A high temperature cycle was used
or Temperature/Fabric control was
set to high.
The load may not be contacting the sensor strips. Level the
dryer.
Use Timed Dry for very small loads. Change the Dry Level
setting on Automatic Dry cycles.
Increasing or decreasing the Dry Level setting will change the
amount of drying time in a cycle.
Lint screen should be cleaned before each load.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Use a cycle with Wrinkle Prevent to tumble the load without heat
to avoid wrinkling.
Dry smaller loads that can tumble freely and reduce formation of
wrinkles.
If so, ventilate the area. When the odors or fumes are gone from
the area, rewash and dry the clothing.
The new electric heating element may have an odor. The odor
will be gone after the first cycle.
Allow Cool Down cycle to finish before removing laundry from
dryer. All cycles are cooled slowly to reduce wrinkling and make
it easier to handle. Items removed before Cool Down may feel
very warm.
Select a lower temperature and use an automatic drying cycle.
These cycles sense the temperature or the moisture level in the
load and shut off when the load reaches the selected dryness.
This reduces overdrying.
Solution
11