Set Up The Communication Address Manually; Work With A Multiple Drive Network; Work With Two Operator Panels - Xylem FLYGT EOP1 Installation, Operation And Maintenance Manual

System Setup and Operation
Symbol

Set up the communication address manually

At the initial start-up, the operator panel sets up the communication address
automatically. To set the address manually, do the following:
1. When the operator panel displays Select Drive Address 01, then adjust the address
2. Confirm the address of the connected drive and press the off button.

Work with a multiple drive network

1. Press the off and down buttons on the operator panel at the same time.
2. Press the up and down buttons on the operator panel to select the drive address.
3. Press the off button to establish the communication between the operator panel and

Work with two operator panels

The operator panels are set to Optipad ID 01 by default.
To ensure the correct operation, change the identity on the second operator panel.
1. Press the navigate, off and down buttons on the operator panel at the same time.
2. Press the up and down buttons on the operator panel to select the operator panel
3. Press the off button to return to the normal operation.
Number of operator panels
One operator panel
Two operator panels
10
from 1 to 63 using the up or down button.
The operator panel displays Select Drive Address xx where xx represents the current
drive address.
the drive.
The operator panel displays Select Optipad ID xx where xx is 01 or 02.
identity.
EOP1 Operator Panel Installation, Operation, and Maintenance manual
Name
Navigate
Up
Off
Down
Hand
Auto
Information
The Optipad ID 01 setting is required for the correct
functionality.
It is impossible to upload new drive software when
Optipad ID 02 is present in the network.
Description
The button is used to enter/exit
(2 seconds) the menu and to confirm
selection/change (< 2 seconds).
The button is used to increase a value
or selection in the submenu.
The button is used to reset a tripped
drive and to stop the drive in manual
mode.
The button is used to decrease a value
or selection in the submenu.
The button is used to enter the
manual mode.
The button is used to enter the
automatic mode