Setting Up - Sensibility Adjustment; Installing The Wired Sensor - Nice Infinity Shock G2 Instructions And Warnings For Installation And Use

11

SETTING UP - SENSIBILITY ADJUSTMENT

Locate the AJUSTE DE SENSIBILIDADE jumper and position it according
to the desired configuration. The instructions are also registered on the
product board.
Minimum Medium Maximum
sensibility sensibility sensibility
12

INSTALLING THE WIRED SENSOR

In order to install the WIRED sensors, no type of setting is required.
The operation of the open or presence sensor is similar, for they inform
the violation of the Zone to the central by opening its contacts. These
contacts should be connected in series when more than one sensor
is used in the same Zone, forcing the electric current to run through all
sensors before returning to the central. This way, if any sensor detects a
violation, its contact will open and the current will be cut off, leading the
central to activate the siren, if enabled. Remove the zone jumper (jumper
JZ) to enable the input of wired sensors. See below an example of the
connections.
51
ENGLISH_