Welch Allyn Schiller AT-2plus Manual page 26

Settings
The defined formats and settings that are set for your unit can be
checked as follows:
Setup Printout
Entry Key Sequence
ALT 0 1
A printout of the defined settings will be produced and gives the
following information, depending on the installed software:
Unit designation Software option installed (i = Interpretation)
and Software version
Serial number Serial number of the unit
Leads Standard (S) or Cabrera (C)
ECG Format Long (ooo), Short (o) or Suppressed (-)
MECG Average cycles as defined in auto ECG recording
setup (e.g. 4 * 3 (25 mm/s) + 2)
Measurements Enabled (+) or Suppressed (-)
1 6
Result
Printout of
1
programmed Settings
Marks
Interpretation
Selected Rhythm leads
Automatic Centering
Printout of signals
Baseline Filter
Mains Filter
Myogram Filter
Memory & Transmission
Enabled (+) or Suppressed (-)
Enabled (+) or Suppressed (-)
Leads selected for R1, R2 resp.
Enabled (+) or Suppressed (-)
Sequential or Simultaneous
0.05, 0.15 or 0.30 Hz
50, 60 Hz or OFF (-)
25 or 35 Hz, ON (+) or OFF (-)
Auto. Storage: ON(+) or OFF(-)
Auto. delete: delete all recordings
after transmission
ON(+) or OFF(-)
Baud rate: 115200, 57600,
38400, 28800,
14400 or 9600
Transmission: Line or Modem