Table of Contents
Advertisement
and tenninal 2 (-). Insure that
polarity is correct.
Install the M option capacitor
assembly. Part No. 4251-014-
00. on the appropriate edge
connector of regulator and
Figure 3-l.
Insure that the external AC protective
device is pmperiy sized for rectffier
input requirements. Close this device
to apply AC input power to the recti-
fier.
HINGED END
Figure 3-I. Capacitor Assembly Connector Location
3)
4)
REGULATOR AND ALARM CIRCUIT CARD A,
CONTROL AND INDICATOR PANEL
(INTERIOR SURFACE)
Section 4387
Place the HVSD circuit breaker toggle
and the POWER rocker switch to the
ON posltn. The rectifier should
start, although the LOW CURRENT
ALARM and an extended rectifier fail
front panel to indicate 52 vofts. At this
time, insert BATTERY DISCONNECT
link S2.
Place the POWER switch to the OFF
position. lf reference leads extended
to the battery or load are required,
reference only is required, disregard
0
Page 5
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
