Canon MultiPASS MP390 Setup Sheet page 6

Install the MP Drivers.
The MP Drivers must be installed on the hard disk of your computer in order to print
from or scan images to the computer. In addition to installing the MP Drivers, install
the MP Toolbox. Use the MP Toolbox to attach scanned images to e-mail, save and
more.
IMPORTANT
• For detailed system requirements, see page 69 of the User's Guide.
• When installing the software in Windows 2000, you must have Service Pack 1 or
later version installed.
• When installing the software in Windows 2000, you must log on as Administrator
or have Administrator privileges, and when installing the software in Windows XP,
you must log on as Administrator.
• If you have an earlier version of the MultiPASS Suite software installed on your
computer, uninstall this version before installing the new version.
For instructions on uninstallation, see the guides for that version of MultiPASS Suite.
• Close any open software applications, including virus checkers prior to installing
the software.
For details, see the instruction guide for each software application.
NOTE
If using the machine with USB 2.0 Hi-Speed mode, you must connect it to a computer
standard-equipped with a USB 2.0 Hi-Speed interface. For details, see page 70 of the User's
Guide.
Prepare the Setup CD-ROM
Turn ON your computer,
and start Windows.
IMPORTANT
(Installation preparation)
Insert the Setup CD-ROM
into the CD-ROM drive.
If the following screen appears, click Cancel.
If you have connected the USB cable,
disconnect it.
The USB cable is connected.
Perform the following steps.
1. Disconnect the USB cable.
2. Click [Cancel].
Click
The setup program should automatically run. If
the setup program does not automatically run,
click [My Computer], then double-click
[setup.exe] or [setup] on the Setup CD-ROM.