Table of Contents
Advertisement
Rexroth Diax 04 HDD and HDS
Connector XS1, shield
attachment of motor cable
DOK-DIAX04-HDD+HDS*UL*-IB01-EN-P
The entire shield of the motor cable is mounted to shield attachment XS1
using the enclosed clamp fitting. It is matched to the diameter of the cable
by simply selecting the relevant clamp base on the mounting panel. The
cable output direction can be either horizontal or vertical and is achieved
by adjusting the mounting panel.
Note:
Always connect shield of cables with a large metal-to-metal
contact surface to shield connection.
For cable cross-sections greater than 25 mm² you can use a special
mounting plate as shield attachment. The following figures show the
mounting plate at the drive controller. You can mount the mounting plate
horizontally or vertically at the drive controller.
Fig. 5-15:
Mounting plate for cable cross-sections greater than 25 mm
Fig. 5-16:
Vertically arranged mounting plate
Instructions for Use
mounting plate
Ap5415f1.fh7
5-9
2
Hide quick links:
Advertisement
Table of Contents
