Water Ace R7L Installation Manual page 5

STEP
4
Remove pipe clamp and slide
the 1-1/2" well seal over rigid
PVC pipe and onto well casing.
Position assembly so that twelve
inches of rigid PVC pipe protrude
from well seal. Alternately turn
bolts on well seal clockwise until
rubber gaskets are tight against
well casing and rigid PVC pipe.
STEP
5
Cement 1-1/2" PVC elbow onto
rigid PVC pipe protruding from
well seal. If desired, some
length may be cut off of rigid
PVC pipe before cementing
elbow. Smooth the inside of any
rigid PVC pipe that has been cut
with a round file or knife.
STEP
6
Thread a 1-1/2" male PVC
adapter into front of pump.
Hand tighten, then turn 1/4 turn
with wrench.
STEP
7
Cement as many sections and couplings of PVC pipe
needed to connect the PVC elbow to the 1-1/2" male PVC
adapter in the front of the pump.
1-1/2" PVC PIPE
STEP
8
Using pipe wrench, thread 1-1/2"
Discharge Tee RDT-15 into top of
pump.
STEP
9
APPROX.
12" OF
PVC PIPE
PROTRUDING
FROM WELL
SEAL
1-1/2"
WELL
SEAL
1-1/2"
PVC
ELBOW
TOP OF
PVC PIPE
PROTRUDING
FROM WELL
SEAL
STEP
9A
PUMP
1-1/2"
MALE PVC
ADAPTER
STEP
10
DISCHARGE TEE
RDT-15
5
Cement as many PVC pipe sections, couplings, and
elbows as needed to connect the 1-1/2" male PVC
adapter to the inground spinkler systems.
NOTE: A new sprinkler system must be flushed to get rid
of construction debris, dirt, etc. So, on a new system,
don't install the sprinkler heads yet (or if they have
been installed, remove them). If you are only replacing
the pump, flushing the system is not necessary.
The completed installation
should look like this.
COMPLETE
CASED WELL
INSTALLATION
Complete all electrical connections as specified on page
1 of the preinstallation instructions.
23833A308