Advertisement
28. Fit ECB LED indicator / park lights (supplied) into protection bar as per instructions supplied with the LED
indicator kit. NOTE: Ensure park light is to outside. See figure 20.
29. Attach ECB 6mm clip lock trim to centre section of protection bar and centre cut out of skirt. See figures 21 and
22.
30. Attach ECB infill trims (supplied) to protector bar. Use M6 nyloc nuts and flat washers (supplied) FINGER
TIGHTEN ONLY. See figure 23.
31. Fit ECB protection bar to outside of steel mounting brackets. Use ½ x 1 ¾ bolts, nuts, flat and spring washers
(supplied). FINGER TIGHTEN ONLY.
32. Align ECB protection bar with vehicle ensuring a gap of 10 to 12mm between protection bar and guard / flare at
sides. See figure 24 for side view and figure 25 for front view TIGHTEN ALL BOLTS. Impact wrench access
is from grille area. NOTE: A 10mm to 12mm gap each side is critical to allow for body/chassis twist in rough
terrain.
33.
Connect indicator / park light wiring and CHECK OPERATION.
34. Carefully drill three 3/16 holes in lower lip on grille, one in centre and one each side, refit grille to vehicle. Zip
tie bottom of grille to head light / indicator assemblies and to steel bracket in centre. See figures 26 and 27.
35. Align ECB infill trims with vehicle and protection bar. TIGHTEN NUTS FIRM ONLY – DO NOT
OVERTIGHTEN.
36. Fit ECB inner guard bracket (supplied) to lower radiator support using one 10mm head bolt from lower bumper
mounts to radiator support and one M6x20 bolt, washer and nyloc nut (supplied)per side. See figure 28. Secure
outer hole in liner to inner guard bracket with bolt supplied M6 x 20 bolt, washers and nyloc nuts (supplied).
Then secure second hole in inner guard bracket to liner with M6 x 20 bolt , washer and nyloc nut (supplied),
ensure this is not pulled to tight as it may cause liner to tear. TIGHTEN bolts and trim any excess liner off. On
passenger side ensure washer bottle stays covered after trim. See figure 29.
Note: When fitting/refitting the licence plate to the vehicle, ensure there is no obstruction to licence plate vision in
accordance with local authorities. If required relocate licence plate to an alternate location.
Further VFPS Notes:
a) Do not attach VFPS to the vehicle using anchorages not intended for this purpose (e.g. engine mounting bolts).
b) Do not use this product for any vehicle make or model, other than those specified by the VFPS manufacturer.
c) Do not remove the plaque or label from the VFPS.
d) Do not modify the structure of the VFPS in any way.
e) No accessory or fitment should project forward of the VFPS forward profile.
f) ENSURE THESE INSTRUCTIONS ARE LEFT WITH VEHICLE OWNER AND/OR OPERATOR.
Periodically check bolts and nuts for correct tightness, especially if travelling on rough roads
.
ENSURE NUMBER PLATE IS CLEARLY VISABLE
IMPORTANT INFORMATION
© Copyright – ECB Pty Ltd – 2012
3
Advertisement
