Test Running Without Water; Method To Test Running Without Water - Panasonic NA-F80GD Service Manual

9 TEST RUNNING WITHOUT WATER

9.1.

METHOD TO TEST RUNNING WITHOUT WATER

1. Set the power switch to "OFF".
2. Press and hold both the "Watet level" and "Wash" buttons with one hand.
3. Set the power switch to "ON".
4. Release the your fingers from the buttons and power switch you pressed in step (2) and (3) above.(Check A and be carried out
in this state with your fingers released.)
5. Within three seconds, press the "Water level" button to set to the desired check procedure. (Carry out check B,C,D,E,G and H.)
Number of times the Check
"Water level" button Mode
is pressed
0 A
1 B
2 C
3 D
4 E
5 G
6 H
Check contents Lamp illumination
condition
· End signal
· Time indication
· Auto power off
· Wash operation
· Feed valve
(To rinse case)
operation
· Spin operation
· Lid switch
operation
· Drying
· Fan
· Heater
· Cock packing
· Set water level 1
rank higher than
laundry amount
detector
· Indicated
Abnormal alarm of
last 2 times
· Indicated
operation times
· When the end buzzer sounds three times,"88" will
simultaneously flash on and off in the remaining time
display, and the power will automatically be switched off
immediately after operation is finished.
If other numbers or characters than "88" appear in the
remaining time display, operate service check B-mode.
· Even if there is no water in the tub, the washing operation
will continue for six minutes.
· Press "Wash" button to change water flow.
· During keep pressing "Rinse" button to check conducting
condition of rinse case's feed valve.
· "H05,H08" is displayed in case of P.C.Board fault.
· The spinning operation will continue for Eight minutes.
· Incase contact point of the lid switch are OFF position,
"Lid" indication light up.
· To check spin operation by opening the lid, press "Wash"
button.
· Drying process shall be operated 2 minutes.
· Rotate the tub approx. 35 rpm, and operate the fan,
heater and cock packing.
· Press the wash button to change L0 to L1 and press
Start/Hold button to confirm.
· "E" shall be indicated initially, Press "Wash" button to
change last time to the time before last and return to E as
initial mode.
· If there were some abnormal alarm in the past, "U or H"
and some number shall be indicated mutually.
If it had no abnormal alarm,"00" mark has displayed.
· "C" shall be indicated initially, Press "Wash" button to
change "Indication of digit of operation times.
Press once:Digit "Thousand-Hundred" for washing
Press twice:Digit "Ten-One" for washing
Press 3 times:Digit "Thousand-Hundred" for drying
Press 4 times:Digit "Ten-One" for drying
Press 5 times to return to "C" digit.
16
Operation condition