Life Fitness ELEVATION 95X Series Assembly Instructions Manual page 8

Install External Power Supply - Discover SE3 and Discover SI Consoles Only
(Explore Optional)
Discover SE3 and Discover SI consoles are powered by an external AC-DC 24-Volt power supply. Plug in the power to
the external power connector on the front end of the Cross-Trainer and then plug the cord into an AC outlet. The con-
sole should immediately beep and light up. The Discover SE3 and Discover SI consoles will show a message indicating
it is initializing (for up to 2 minutes).
Note: If any of the consoles do not light up, contact LIFE FITNESS Customer Service (refer to page one of this manual).
Use only the power supply provided by Life Fitness in order to ensure against unsafe operation.
The following connection receptacles are located at the front of the Elevation
Series 95X Cross-Trainer with Discover Consoles:

External Power for Discover Console (A),

Coaxial Cable (B), and

Ethernet Cable (C).
Note: CSAFE connections must be made at the console only.
CAUTION: Connectors should easily fi t into the receptacles. Forcing a connection may lead to damage to the barrel
connector and/or receptacle and may void product warranty. If the power supply barrel doesn't fi t easily into the re-
ceptacle then the wrong power supply is being used.
Cable TV Hook-Up - Discover SE3 Consoles Only
The Discover SE3 console can receive both analog and digital signals. LIFE FITNESS is not responsible for the installa-
tion of CATV service or components required for the delivery of CATV service. An external TV signal input via a 75-ohm
coaxial cable must be present before TV setup can occur.
Note to the CATV Installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guide-
lines for proper grounding and, in particular, specifi es that the cable ground shall be connected to the grounding sys-
tem of the building as close to the point of cable entry as practical.
A
B
C
7